Input Voltage:
The range of input voltage is from 90VAC to 260VAC |
Input Frequency:
The range of input frequency is between 47Hz to 63Hz |
Input Current:
The maximum input current is 3A at 115VAC or 1.5A at 230VAC |
Inrush Current:
The inrush current is less than 30A at 115VAC input or 60A at 230VAC input, cold start at 25°C |
Load Range:
At the factory, the +5V output is set between 5.08V to 5.13V and all output at 60% rated load and the other outputs are checked to be within the accuracy range. The maximum total combined output power on the 3.3V and 5V rails is 70W, and the max. load cannot be exceed 120W |
Ripple And Noise:
The peak to peak ripple and noise for +5V, +3.3V output are less than 50mV for +5Vsb is 120mV, for +12V is less than 120mV, for -12V is less than 200mV at ranted load and nominal input, which is measured by a 15MHz bandwidth limited oscilloscope and the each output is connected with 0.47uF capacitor |
Line Regulation:
The line regulation is less than +/-1% at rated load with +/-10% change in input voltage |
Load Regulation:
The load regulation for +5V is less than +/-2%, for +12V is less than +7%~-3%, for -12V is +8%~-3%, +3.3V is less than +/-5% while the measuring is done by changing the measured output loading +/-40% from 60% rated load, and keep other output is at 60% rated load |
Hold Up Time:
The hold up time is longer than 16mS at 115VAC input and rated load |
Power ON/OFF:
The powe supply will be turned on when the power On/Off pin is connected to secondary GND |
Efficiency:
The efficiency is higher than 70% while measuring at nominal line and rated load |
Altitude:
0~10,000ft |
Protection:
The power supply will generate the hiccup mode to protect itself against short circuit or over load condition, and will return to normal after wrong condition is removed |
Over Voltage Protection:
For some reason the power supply fails to control itself, the build-in over voltage protection circuit will shut down and into latch off model |
Temperature:
0~+50°C, output power 120W with min. 38CFM forced air, and 85W fan-less |
Dimensions:
15.24 x 8.381 x 4.0 cm. Tolerance specified is +/-0.4mm |
|