 |
Total Output Power:
100W at 50°C environment temperature (Note 3)
Note:
1) The maximum total combined output power on the +3.3V and +5V rails is 40W
2) Measured by a 20MHz bandwidth limited oscilloscope and the each output is connected with a 10uF Electrolytic Capacitor and a 0.1uF Ceramic Capacitor
3)
 |
Input Specification:
 |
Power On/Off:
The power supply will be turned on when the power On/Off pin is connected to secondary GND |
Power Good Signal:
When power is turned on, the power good signal will go high 100ms to 500ms after all output DC voltages are within regulation limits |
Power Fail Signal:
The power fail signal will go low at least 1mS before any of the output voltages fall below the regulation limits |
Over Load Protection:
Fully protected against output overload and short circuit. Automatic recovery upon of overload condition |
Over Voltage Protection:
The build-in over voltage protection circuit will shut down the outputs to prevent damaging external circuits. The trigger point is about 5.8-6.8V at +5V. If the OVP occur, PSU will into latch off model |
Environment Specification:
 |
Dimensions:
12.8 x 8.1 x 4.0 cm, Tolerance +/-0.4mm |
|
