 |
Total Output Power:
150W at 50°C environment temperature
Note:
1) The maximum total combined output power on the +3.3V and +5V rails is 90W
2) Measured by a 20MHz bandwidth limited oscilloscope and the each output is connected with a 10uF Electrolytic Capacitor and a 0.1uF Ceramic Capacitor
3) Initial Setting Accuracy is at Input 24VDC and all output at 60% rated load |
Input Specification:
 |
Power On/Off:
The power supply will be turned on when the power On/Off pin is connected to secondary GND |
Power Good Signal:
When power is turned on, the power good signal will go high 100ms to 500ms after all output DC voltages are within regulation limits |
Power Fail Signal:
The power fail signal will go low at least 1mS before any of the output voltages fall below the regulation limits |
Short Circuit Protection:
Fully protected against short circuit. Latch off mode upon of short circuit condition |
Over Voltage Protection:
For some reason the power supply fails to control itself, the build-in over voltage protection circuit will shut down the outputs to prevent damaging external circuits. The trigger point is about 5.4-7V at +5V. If the OVP occur, PSU cannot be recovered |
Over Temperature Protection:
When the power supply operating over the temperature or over load limit, the powre supply will be shut down automatically to protect itself. The protection point is at the temperature of the T1 over 125°C. After the temperature of T1 going down, the power supply will restart automatically |
Environment Specification:
 |
Dimensions:
19.8 x 9.7 x 4.0 cm, Tolerance +/-0.4mm |
|
