 |
Total Output Power:
100W continuously maximum covection cooling, peak 120W with foreced air (Note 4)
Note:
1) The maximum total combined output power on the +3.3V and +5V rails is 50W
2) Measured by a 20MHz bandwidth limited oscilloscope and the each output is connected with a 10uF Electrolytic Capacitor and a 0.1uF Ceramic Capacitor
3) The +5V output is set between 5.08V to 5.13V by variable resistor and all output at 60% rated load and the other outputs are checked to be within the accuracy range
4) Total maximum output power 100W at 25°C and 80W at 50°C convection cooling. Maximum 100W and peak 120W with 10.2CFM forced air-cooling |
Input Specification:
 |
Power On/Off:
The power supply will be turned on when the power On/Off pin is connected to secondary GND |
Power Good Signal:
When power is turned on, the power good signal will go high 100ms to 500ms after all output DC voltages are within regulation limits |
Power Fail Signal:
The power fail signal will go low at least 1mS before any of the output voltages fall below the regulation limits |
Over Load Protection:
Fully protected against output overload and short circuit. Automatic recovery upon of overload condition |
Over Voltage Protection:
For some reason the power supply fails to control itself, the build-in over voltage protection circuit will shut down the outputs to prevent damaging external circuits. The trigger point is about 5.8V-6.8V at +5V. If the OVP occur, PSU cannot be recovered |
Environment Specification:
 |
Dimensions:
17.05 x 8.3 x 4.1 cm, Tolerance +/-0.4mm |
|
